Friday, January 8, 2010

Thoughts before breakfast

So I started out thinking this morning about the rotary electrical unions. In thinking about it, I feel it'd be a bad idea to buy these. They're extremely hard to find and very expensive when you do. Most of them are made for high power environments (such as generators) so are way bigger than we'd need. I spent a bit of time talking to Carl Pisaturo about his rotary unions at Dorkbot a while back. Although his are very pretty, I think we could come up with something a lot less polished that would do the job slightly more off the shelf, but following about the same concept of rings and combs. These could be constructed as "caps" that go on the tops of each of the legs. I do think more thinking is required in the comb part. I'm not convinced of Carl's use of stainless steel as a conductor for the comb.

But a new problem struck me as I was mulling over the legs. How to stabilise them, attach the drive motors to the wheel and still have full rotary motion. It seems that for greatest stability, the motor should be as close to the wheel as possible, allowing the shaft to be stabilised and supported at multiple points along the greatest length. This makes good sense, but sticks the motor way down in the dust and mud. Will this be a problem? I'm hoping that for the automotive-style motors I'd consider, the answer is no.

No comments:

Post a Comment